Home » Bearings Catalog » Pillow Blocks, Flanges, Take Up Units and Bearing Inserts » Collar Clamp Ball Bearings » S1PPG7-4

S1PPG7-4

Category: Collar Clamp Ball Bearings





(Qty)
  1. The bearing comes with a retaining ring.
  2. Bore tolerance = +0000" / -.0005"
  3. Outside diameter tolerance = .0000" / -.0004"
  4. Outer race width tolerance = .000" / -.005"
  5. Inner race width tolerance = .000" / -.005"
  6. All tolerances ABEC 1 except where noted.
  7. Two rubber seals
  8. Mating shaft recommended tolerance: +.0000" / -.0005"
Attributes Values
Bearing Type with snap ring
Bore Dia (d) 0.1875
Outer Dia (D) 0.6250
Outer Width (Bo) 0.1960
Inner Width (Bi) 0.4219
Dynamic Load Rating (Cr) 168
Static Load Rating (Cor) 77
Collar Width (i) 0.1880
Bearing Collar Outside Dia. (J) 0.5630
Bearing Collar Set Screw (L) 4-40 UNC
Snap Ring Dia. (G) 0.7340
Snap Rinf Location (Sd) 0.7000
Snap Ring Thickness (I) 0.0260
Material 52100 chrome steel, or equivalent
Additional Information
General
Nomenclature
Material
Closures and Seals
Cages and Retainers
Tolerances and Precision
Internal Clearance
Lubrication
Fitting and Mounting
Load and Life Calculation Information
eDrawings file (.ePRT, eASM)
The information in AST Bearings herein is provided for informational purposes only. This information should not be relied upon for design, development or other purposes.
Contact AST Bearings for the most current product information as it applies to you and for your product information.